D-Link DIR-600 - Page 39

34D-Link DIR-600 User Manual
Section 3 - Conguration
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specic ISP. 1454 is the default
MTU.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s MAC Address button to
replace the Internet port’s MAC address with the MAC address of your Ethernet card.
If your ISP requires you to manually specify the WAN Physical IP settings, click the Static IP radio button and enter the required IP
Address, Subnet Mask, Gateway, and DNS Server Addresses in their respective elds.
MTU:
MAC Address:
WAN Physical
Settings:
Click the Save Settings button to save any changes made.