D-Link DIR-600 - Routing

51D-Link DIR-600 User Manual
Section 3 - Conguration
To enable a route, check the box that is on the left side of
the route.
Use the drop-down menu to specify if the IP packet must
use the WAN or LAN interface to transit out of the Router.
Enter the IP address of the packets that will take this route.
Enter the subnet mask to specify the subnet of the IP
packets that will take this route.
Enter the next hop that will be taken if this route is used.
Enable:
Interface:
Destination:
Subnet Mask:
Gateway:
Routing
The Routing option is an advanced method of customizing specic routes of data through your network.
Click the Save Settings button to save any changes made.