D-Link DIR 635 B3 - Configuration; Dynamic (Cable)

18D-Link DIR-635 User Manual
Section 3 - Configuration
Select Dynamic IP (DHCP) to obtain IP Address
information automatically from your ISP. Select
this option if your ISP does not give you any IP
numbers to use. This option is commonly used
for cable modem services such as Comcast
and Cox.
The Host Name is optional but may be required
by some ISPs. Leave blank if you are not sure.
Check the box if you are having problems
obtaining an IP address from your ISP.
Enter the primary and secondary DNS server
IP addresses assigned by your ISP. These
addresses are usually obtained automatically
from your ISP. Leave at 0.0.0.0 if you did not
specically receive these from your ISP.
Maximum Transmission Unit - you may need to
change the MTU for optimal performance with your specic ISP. 1500 is the default MTU.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s
MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet
Connection:
Host Name:
MAC Address:
Dynamic(Cable)
Primary/
Secondary DNS
Server:
MTU:
Use Unicasting: