D-Link DIR 635 B3 - Application Rules

36D-Link DIR-635 User Manual
Section 3 - Configuration
Enter a name for the rule. You may select a
pre-dened application from the drop-down
menu and click <<.
Select either a single port or a range of ports.
This port triggers the pre-dened application.
Select the protocol for the trigger port - TCP,
UDP, or Both.
This is the port number on the Internet side
that will be used to access the application. You
may dene a single port or a range of ports.
You can use a comma to add multiple ports or
port ranges.
Select the protocol for the rewall port- TCP,
UDP, or Both.
The schedule when the Application Rule is
enabled. The schedule may be set to Always,
which will allow the particular service to always
be enabled. You can create your own times in
the Tools > Schedules section.
Name:
Trigger:
Traffic Type:
Firewall:
Traffic Type:
Schedule:
Application Rules
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and
others. These applications have difculties working through NAT (Network Address Translation). Special Applications
makes some of these applications work with the DIR-635. If you need to run applications that require multiple connections,
specify the port normally associated with an application in the Trigger Port eld, select the protocol type as TCP or
UDP, then enter the rewall (public) ports associated with the trigger port to open them for inbound trafc.
The DIR-635 provides some predened applications in the table on the bottom of the web page. Select the application
you want to use and enable it.