D-Link DIR 635 B3 - Connect Using WCN 2.0 in Windows Vista

78D-Link DIR-635 User Manual
Section 5 - Connecting to a Wireless Network
Connect Using WCN 2.0 in Windows Vista
®
The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista
®
. The following instructions for setting
this up depends on whether you are using Windows Vista
®
to congure the router or third party software.
When you rst set up the router, Wi-Fi protection is disabled and not congured. To enjoy the benets of Wi-Fi protection,
the router must be both enabled and congured. There are three basic methods to accomplish this: use Windows Vista’s
built-in support for WCN 2.0, use software provided by a third party, or manually congure.
If you are running Windows Vista
®
, log into the router and click the Enable checkbox in the Basic > Wireless section.
Use the Current PIN that is displayed on the Advanced > Wi-Fi Protected Setup section or choose to click Generate
New PIN or Reset PIN to Default.
For additional information, please refer to page 68.
If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are nished,
proceed to the next section to set up the newly-congured router.