D-Link DIR-809 - Page 100

96D-Link DIR-809 User Manual
Section 3 - Conguration
STEP 5: PORT FILTER
Add Port Filters Rules.
Specify rules to prohibit access to specic IP addresses and ports.
Enable Name Dest IP Start Dest IP End Protocol Dest Port Start Dest Port End
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
☑
0.0.0.0 255.255.255.255 Any
▼
1 65535
Prev Next Save Cancel
STEP 6: CONFIGURE WEB ACCESS LOGGING
Select the method for ltering.
Web Access Logging :
 Disabled
 Enabled
Prev Next Save Cancel
Add Policy (continued)
Enable: Check the box to enable this rule.
Name: Enter a name for port ltering rule.
Dest IP Start: Enter the start of the IP address range to lter.
Dest IP End: Enter the end of the IP address range to lter.
Protocol: Select the protocol to apply the port lter to. The options are Any,
ICMP, TCP, and UDP.
If you select TCP or UDP, enter the port range:
Des Port Start: Enter the start of the port range to lter.
Des Port End: Enter the end of the port range to lter.
Click Next to continue.
STEP 5: PORT FILTER
Web Access
Logging:
Enable or disable Web Access logging. You may view the web access
log from the Status > Logs section of the web conguration utility.
Click Save to nish.
STEP 6: CONFIGURE WEB ACCESS LOGGING
If you selected Block Some Access, congure the following options: