40
Wireless (2.4GHz)
Basic settings
Here we will configure the settings for the 2.4Ghz Network.
Disable Wireless LAN Interface: Set the Wireless state to Enabled or
Disabled.
Country or Region: Choose your country of origin
Band: Select a wireless band
Mode: Select mode AP/Client
SSID: Set a name for your wireless network
Channel Width: Select the channel width of 20Mhz, 40Mhz or 20/40Mhz
Control Sideband: Set the Sideband to Upper or Lower.
Channel Number: Select a wireless channel number between 1-13
(recommended to use 1/6/11)
RX Chain Power Safe: Enable/Disable
Broadcast SSID: Enable to Broadcast the SSID (Wi-Fi Name)
WMM: Turn Wi-Fi Multimedia on/off.
Data Rate: Set the Rate to Auto or a selected value.
Associated clients: Click to show Active wireless clients
Enable Universal Repeater mode: Tick to Enable Universal Repeater
mode.
To Next Page
Loading...
