D-Link DIR-846 - Connect a Wireless Client; WPS Button Connection

D-Link DIR-846 User Manual
- 50 -
Connect a Wireless Client to your Router
WPS Button
The easiest and most secure way to connect your wireless devices to the router is with WPS (Wi-Fi Protected Setup). Most
wireless devices such as wireless adapters, media players, Blu-ray DVD players, wireless printers and cameras will have a WPS
button (or a software utility with WPS) that you can press to connect to the DIR-846 router. Please refer to your user manual for
the wireless device you want to connect to make sure you understand how to enable WPS. Once you know, follow the steps
Below:
Step 1 - Press the WPS button on the DIR-846/846W for about 1 second. The Internet LED on the front will start to blink.
Step 2 - Within 2 minutes, press the WPS button on your wireless device (or launch the software utility and start the WPS
process).
Step 3 - Allow up to 1 minute for your connection to be configured. Once the Internet light stops blinking, you will be
connected and your wireless connection will be secure with WPA2.
Note:DIR-846 only supported 2.4G wireless WPS button.