D-Link DIR-880L - Settings (Router Mode)

33D-Link DIR-880L User Manual
Section 3 - Conguration
Settings (Router Mode)
Wizard
Internet
From the Settings menu on, click Wizard to open the Setup Wizard. This is the same wizard that appeared when you
rst installed the router. After installation, unless you reset the DIR-880L to the factory default settings, you can only
access the wizard when the DIR-880L is set to Router Mode.
From the Settings menu on the bar on the top of the page, click Internet for Internet conguration when in Router Mode.
Choose your Internet Connection type from the drop-down menu.
Depending on the connection type that you select, you may also see
additional elds below that require input. For example, when you
select PPPoE, you will see elds for Username and Password.
My Internet
Connection is:
Click Advanced Settings... to expand the list and see all elds for the selected option.
For Dynamic IP (DHCP) refer to page 34.
For Static IP refer to page 35.
For PPPoE refer to page 36.
For PPTP refer to page 37.
For L2TP refer to page 39.
For DS-Lite refer to page 41.