D-Link DIR-880L - Page 75

71D-Link DIR-880L User Manual
Section 3 - Conguration
Enter a Name for the new rule.
This is the IP address of the router used to reach the specied
destination.
Enter the IPv6 address prex length of the packets that will take this
route.
Enter the metric value for this rule here.
Select the interface that the IP packet must use to transit out of the
router when this route is used.
Click Apply when you are done.
Name:
DestNetwork:
PrexLen:
Metric:
Interface:
IPv6
If you wish to remove a route, click on its trash can icon in the Delete column. If you
wish to edit a route click on its pencil icon in the Edit column. If you wish to create a
new route, click the Add Route button. Click Save when you are done.
When you click on Add Route, the Create New Route window will open. Enter the
required information into the elds described below:
To congure IPv6 rules, from the Static Routes page click IPv6.
To return to the main IPv4 static routes page, click IPv4.