D-Link DMS-107 - SWITCH SET-UP; Step 1: Power Connection; Step 2: Network Device Connection; Step 3: Verify Connection

3
ENGLISH
PRODUCT SETUP
SWITCH SET-UP
Step 1
Plug the power adapter into a free wall socket, then plug the other
end of the power adapter cable into the power port of the switch.
The power LED will light up, conrming that the device is powered
up successfully.
Step 2
Use a LAN cable to connect your network device to one of the 7
ports on the switch.
Step 3
Check the Link/Act lights(LEDs) on the switch to verify a proper
connection.
Router
Internet
Status LED
Power
LAN LAN LAN LAN
LAN