D-Link DSL-514 - Adsl

DSL-514 ADSL Router User’s Guide
62
ADSL
The ADSL Configuration page allows the user to set the configuration for ADSL protocols.
Trellis: This field allows the user to enable or disable the Trellis Code. By default, it is always enabled.
Handshake Protocol: This field allows the user to select the ADSL handshake protocol.
Wiring Selection: This field allows the user to enter the wiring selection for RJ-11. Tip/Rip is the default
for the board without the inner/outer pair relay.
Bit Swapping: This field allows the user to enable or disable the upstream bit swapping.