............................................................................................................................................................................................................................................................
Install the CPEInstallation Guide
1-2
Issue 1 February 2011
............................................................................................................................................................................................................................................................
Figure 1-1 Overview about all external connections
System requirements and safety guidelines
1. The CPE should be located in a cool dry place, with at least 5 cm (2 in.) of space on all
sides for ventilation. Place the CPE out of direct sunlight, and away from heat sources
or areas with a high amount of electromagnetic interference.
2. For power supply, the CPE requires 15 V DC via the supplied power adapter.
3. Do not spill any liquid on this CPE.
4. The CPE is a plug-and-play unit and does not need any configuration or maintenance.
5. Do not place the CPE on an unstable stand or table; the CPE may drop and become
damaged.
6. For an Internet access, a PC with a 10/100 Mb/s Ethernet adapter card installed is
required. And it must be configured for a connection method which should be obtained
from the ISP. Please consult your ISP for connection requirement.
Before you begin
Make sure that the package content is complete. Preserve original carton and packaging
material.
To Next Page
Loading...
Need help?
General
