17
You can Enable or Disable
the IP Settings portion
of your profile here. If
you select Disable you
will need to configure the
IP address information
each time you connect to
a network. If you select
Enable you will maintain
th e sa me IP a dd ress
information each time you
connect to a network.
Using the Configuration Utility with Windows OS (continued)
Advanced
Ad-Hoc Channel:
All devices in the Ad-Hoc
network must be set to the
same channel.
Click Apply if you have made any changes.
Data Packet Parameter:
Select the parameters here.
Profile IP Settings:
Select Enable or Disable.
Launch Utility on Startup:
Power Mode:
Disable -This default setting consumes the most power.
Enable - This setting consumes the least power.
Fragmentation Threshold:
This value should remain at its default setting of 2432. If you experience
a high packet error rate, you may slightly increase your Fragmentation
Threshold within the value range of 256 to 2432. Setting the Fragmentation
Threshold too low may result in poor performance.
This value should remain at its default setting of 2432. If inconsistent data
flow is a problem, only a minor modification should be made.
RTS Threshold:
To Next Page
Loading...
