Virtual Router Redundancy Protocol Commands 133
3 Routing Commands
Mode Interface Config
ip vrrp timers advertise
This command sets the frequency, in seconds, that an interface on the specified virtual router
sends a virtual router advertisement.
Default 1
Format
ip vrrp <vrid> timers advertise <1-255>
Mode Interface Config
no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
Format
no ip vrrp <vrid> timers advertise
Mode Interface Config
show ip vrrp interface stats
This command displays the statistical information about each virtual router configured on the
switch.
Format
show ip vrrp interface stats <slot/port> <vrid>
Modes Privileged EXEC
User EXEC
Uptime The time that the virtual router has been up, in days, hours, minutes and sec-
onds.
Protocol The protocol configured on the interface.
State Transitioned to Master The total number of times virtual router state has changed to
MASTER.
Advertisement Received The total number of VRRP advertisements received by this virtual
router.
Advertisement Interval Errors The total number of VRRP advertisements received for
which advertisement interval is different than the configured value for this
virtual router.
Authentication Failure The total number of VRRP packets received that don't pass the
authentication check.
IP TTL errors The total number of VRRP packets received by the virtual router with IP TTL
(time to live) not equal to 255.
Zero Priority Packets Received The total number of VRRP packets received by virtual
router with a priority of '0'.
Zero Priority Packets Sent The total number of VRRP packets sent by the virtual router
with a priority of '0'.
Invalid Type Packets Received The total number of VRRP packets received by the virtual
router with invalid 'type' field.
To Next Page
Loading...
