D-Link DWL-8500AP

Class of Service (CoS) Commands 229
5 Quality of Service (QoS) Commands
no classofservice trust
This command sets the interface mode to the default value.
Format
no classofservice trust
Modes Global Config
Interface Config
cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface
queue. The total number of queues supported per interface is platform specific. A value from
0-100 (percentage of link rate) must be specified for each supported queue, with 0 indicating
no guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
Format
cos-queue min-bandwidth <bw-0> <bw-1> … <bw-n>
Modes Global Config
Interface Config
no cos-queue min-bandwidth
This command restores the default for each queue's minimum bandwidth value.
Format
no cos-queue min-bandwidth
Modes Global Config
Interface Config
cos-queue strict
This command activates the strict priority scheduler mode for each specified queue.
Format
cos-queue strict <queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes Global Config
Interface Config
no cos-queue strict
This command restores the default weighted scheduler mode for each specified queue.
Format
no cos-queue strict <queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes Global Config
Interface Config
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a
whole. Also known as rate shaping, traffic shaping has the effect of smoothing temporary
traffic bursts over time so that the transmitted traffic rate is bounded.
Format
traffic-shape <bw>
Modes Global Config
Interface Config