Class of Service (CoS) Commands 227
5
Quality of Service (QoS) Commands
This chapter describes the Quality of Service (QoS) commands available in the D-Link
Unified Wired/Wireless Access System CLI.
The QoS Commands chapter contains the following sections:
• “Class of Service (CoS) Commands” on page 227
• “Differentiated Services (DiffServ) Commands” on page 232
• “DiffServ Class Commands” on page 233
• “DiffServ Policy Commands” on page 237
• “DiffServ Service Commands” on page 241
• “DiffServ Show Commands” on page 242
• “MAC Access Control List (ACL) Commands” on page 246
• “IP Access Control List (ACL) Commands” on page 249
The commands in this chapter are in one of two functional groups:
• Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the configuration
setting.
• Show commands are used to display device settings, statistics and other information.
Class of Service (CoS) Commands
This section describes the commands you use to configure and view Class of Service (CoS)
settings for the switch. The commands in this section allow you to control the priority and
transmission rate of traffic.
NOTE: Commands you issue in the Interface Config mode only affect a single inter-
face. Commands you issue in the Global Config mode affect all interfaces.
classofservice dot1p-mapping
This command maps an 802.1p priority to an internal traffic class. The <userpriority>
values can range from 0-7. The
<trafficclass> values range from 0-6, although the actual
number of available traffic classes depends on the platform. For more information about
802.1p priority, see “Provisioning (IEEE 802.1p) Commands” on page 64.
To Next Page
Loading...
