D-Link DWR-953V2 - Product Setup; Connect to LTE Connection; Connect to Modem; Connect PC to Router

DWR-953V2
2
ENGLISH
Ensure that your DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router is powered off before performing the
steps below.
Step 1:
If you are connecting to a LTE connection, insert a standard
USIM card into the SIM card slot on the side of the router.
Note: Do not attempt to insert a Nano SIM or Micro SIM into the SIM
card slot.
Step 2:
If you are connecting this router to a modem, insert one end of
an Ethernet cable into the Gigabit WAN/LAN port on the back of the
router and the other end into your wired Internet connection device.
Note: When connected to a modem, by default, the LTE connection
will be used as the main WAN connection. The router will
automatically use the wired connection if the LTE connection is not
available.
Step 3:
Insert the supplied Ethernet cable into a LAN port on the back panel
of the DWR-953V2, and an available Ethernet port on the computer
you will use to congure the unit.
SIM
card
Router
Router
PC
Modem
Step 5:
To congure the DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router:
Open a web browser window and enter 192.168.0.1 into the address
bar.
Enter admin for the username and leave the password area blank.
Step 4:
Connect the power adapter to the power input on the back panel of
your DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router. Plug the other
end of the power adapter into a wall outlet or power strip and press
the power button down.
The POWER LED on the router will light up to indicate that power is
being supplied to the router.
Router
Modem
PC
Router
Modem
PRoDuCT SETuP