Technical Support Setup Procedure
How to configure the wireless network name (SSID) and
wireless password (WPA Key) on my DWR-M930 4G LTE
Router?
1 Connect your PC to the router via an Ethernet cable or connect wirelessly to the dlink-
xxxx (xxxx is the last 4 digits of mac address) from the Wi-Fi list of the device you want
to connect from. When prompted for a password, use the WPA key printed at the bottom
of the router or by pushing the WPS button at the back of the Router.
Note: If you are having trouble connecting the PC wirelessly then try connecting it by
wired connection to one of the LAN ports on the back of the LTE Router.
2 Access the router’s web interface by entering its IP address into a web browser on the
address bar http://192.168.0.1 then press enter.
3 The page will be prompted to enter a username and password. The default username
and the default password are:
Username: admin
Password: (as printed on the device label bottom of the router)
Note: If you have changed the password and cannot remember it, you will need to reset
the router to factory defaults.
4 Once login, Click on the ‘Wireless’ tab at the top of the page then ‘Basic Settings’
To Next Page
