D-Link G416

59D-Link G416 User Manual
Section 3 - Conguration
DHCP Server
Status Enable or disable the DHCP server.
DHCP IP Address
Range
Enter the start and end IP addresses for the DHCP server's IP
assignment. Note: If you statically assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may have an IP conict.
DHCP Lease Time Enter the length of time for the IP address lease in minutes.
The default is 10080 minutes.
Always Broadcast Enable this feature to broadcast your network's DHCP server
to LAN/WLAN clients.
Advanced Settings...
WAN Port Speed You may set the link speed of the Internet port to 10 Mbps,
100 Mbps, 1000 Mbps, or Auto (recommended).
UPnP Enable or disable Universal Plug and Play (UPnP). UPnP
provides compatibility with networking equipment, software,
and peripherals. This is enabled by default.
IPv4 Multicast Streams
Allow or disallow IPv4 multicast trac to pass through the
router from the Internet. This is enabled by default.
IPv6 Multicast Streams
Allow or disallow IPv6 multicast trac to pass through the
router from the Internet. This is enabled by default.