EasyManuals Logo

D-Link GO-RT-N300 Quick Installation Guide

D-Link GO-RT-N300
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
GO-RT-N300
6
ENGLISH
TROUBLESHOOTING
SET-UP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY GO-RT-N300 ROUTER FOR A PERSONALIZED
WIRELESS NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the router using an Ethernet cable.
- Open a web browser and enter the address http://192.168.0.1
- The default username is ‘Admin’. The default password is to leave the eld blank.
- If you have changed the password and can not remember it, you will need to reset the router to
set the password back to a blank eld.
2. HOW DO I RESET MY GO-RT-N300 ROUTER TO FACTORY DEFAULT SETTINGS?
- Ensure the router is powered on.
- Press and hold the reset button on the rear of the device for 10 seconds.
Note: Resetting the router to factory default will erase the current conguration settings. To re-
congure your settings, log into the router as outlined in question 1, then run the Setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- Every PC that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless Network Name (SSID) and encryption key.
- Use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected PC. You will nd a dedicated area on the back of this document, this important
information for future use.
4. WHY CAN I NOT GET AN INTERNET CONNECTION?
- For ADSL users please contact your ISP to make sure the service has been enabled/connected
by your ISP and that your ISP username and password is correct.
For full product manual, please refer to the website www.dlink.com
To download the latest rmware, please refer to the website www.dlink.com
TECHNICAL SUPPORT
United Kingdom (Mon-Fri) website: http://www.dlink.co.uk FTP: ftp://ftp.dlink.co.uk
Home Wireless/Broadband 0871 873 3000 (9.00am–06.00pm, Sat 10.00am-02.00pm)
Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am- 05.30pm)
(BT 10ppm, other carriers may vary.)
Ireland (Mon-Fri)
All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm)
Phone rates: €0.05ppm peak, €0.045ppm off peak times

Other manuals for D-Link GO-RT-N300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link GO-RT-N300 and is the answer not in the manual?

D-Link GO-RT-N300 Specifications

Wireless Signal Rates IconWireless Signal Rates
IEEE 802.11n 20MHz channel150 Mbps (max)
IEEE 802.11n 40MHz channel300 Mbps (max)
IEEE 802.11g rates54 Mbps - 48 Mbps - 36 Mbps - 24 Mbps - 18 Mbps - 12 Mbps - 11 Mbps - 9 Mbps - 6 Mbps
Operating Environment IconOperating Environment
operating temperature0 °C to 40 °C (32 °F to 104 °F)
storage temperature-20 °C to 65 °C (-4 °F to 149 °F)
humidity10% minimum to 95% maximum (non-condensing)
Dimensions IconDimensions
length160 mm (6.3 inches)
width120 mm (4.72 inches)
height59 mm (2.32 inches)

Related product manuals