3. Define a User Authentication Rule, this is almost identical to L2TP:
Agent Auth Source Src Network Interface Client Source IP
PPP Local all-nets pptp_tunnel all-nets (0.0.0.0/0)
4. Now set up the IP rules in the IP rule set:
Action Src Interface Src Network Dest Interface Dest Network Service
Allow pptp_tunnel pptp_pool any int_net All
NAT pptp_tunnel pptp_pool ext all-nets All
As described for L2TP, the NAT rule lets the clients access the public Internet via the NetDefend
Firewall.
5. Set up the client. For Windows XP, the procedure is exactly as described for L2TP above but
without entering the pre-shared key.
9.2.7. PPTP Roaming Clients Chapter 9. VPN
350
To Next Page
Loading...
