Chapter 13. Advanced Settings
This chapter describes the configurable advanced settings for NetDefendOS. The settings are
divided up into the following categories:
Note: Activating changes
After any advanced setting is changed, the new NetDefendOS configuration must be
deployed in order for the new value to take effect.
• IP Level Settings, page 453
• TCP Level Settings, page 457
• ICMP Level Settings, page 462
• State Settings, page 463
• Connection Timeout Settings, page 465
• Length Limit Settings, page 467
• Fragmentation Settings, page 469
• Local Fragment Reassembly Settings, page 473
• Miscellaneous Settings, page 474
13.1. IP Level Settings
Log Checksum Errors
Logs occurrences of IP packets containing erroneous checksums. Normally, this is the result of the
packet being damaged during network transport. All network units, both routers and workstations,
drop IP packets that contain checksum errors. However, it is highly unlikely for an attack to be
based on illegal checksums.
Default: Enabled
Log non IP4
Logs occurrences of IP packets that are not version 4. NetDefendOS only accepts version 4 IP
packets; everything else is discarded.
Default: Enabled
Log Received TTL 0
Logs occurrences of IP packets received with the "Time To Live" (TTL) value set to zero. Under no
circumstances should any network unit send packets with a TTL of 0.
Default: Enabled
Block 0000 Src
453
To Next Page
Loading...
