Need help?Do you have a question about the D-Link Web Smart DES-1228P and is the answer not in the manual?
General| PoE Ports | 24 |
|---|---|
| Switching Capacity | 12.8 Gbps |
| MAC Address Table | 8K |
| Flash Memory | 16 MB |
| Jumbo Frame | 9K |
| Power Supply | Internal |
| Type | Web Smart |
| Dimensions | 440 x 44 mm |
| Operating Temperature | 0 to 40 °C (32 to 104 °F) |
| Storage Temperature | -40 to 70°C |
| Humidity | 10% to 90% non-condensing |
Procedure for unpacking the switch and verifying all contents.
Instructions for installing the switch on a desktop or in a rack.
Connecting the power cord to the switch and a power outlet.
Process for logging into the switch's web interface using IP address and password.
Guided setup for initial switch configuration before accessing the main utility.
Explanation of the PoE option and its capabilities for powering devices.
Configuring device settings, passwords, firmware, and DHCP via SmartConsole.
Using the Smart Wizard for initial guided configuration and password settings.
Configuring IP address, system name, location, and login timeout settings.
Enabling and configuring SNMP settings, including community names and trap settings.
Performing system reset, backup/restore, and firmware updates via the Tool Menu.
Detailed configuration of IP information, system information, and group interval.
Monitoring and adjusting port status, speed, and flow control settings.
Enabling and configuring IGMP snooping for efficient multicast traffic forwarding.
Configuring Spanning Tree Protocol to prevent network loops and ensure redundant paths.
Managing Power over Ethernet settings for individual switch ports, including enable and power limit.
Configuring Quality of Service for 802.1p and DSCP priority settings for traffic prioritization.
Configuring IEEE 802.1X for network access control and port authentication via RADIUS.
To Next Page
