Need help?Do you have a question about the D-Link DGS-1224TP - Web Smart Switch and is the answer not in the manual?
General| Device Type | Switch - 24 ports - managed |
|---|---|
| Subtype | Gigabit Ethernet |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| Layer | Layer 2 |
| Power | AC 120/230 V (50/60 Hz) |
| Packet Buffer Memory | 1.5 MB |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| IGMP Snooping | Yes |
| Flow Control | Yes |
| Enclosure Type | Rack-mountable |
| MAC Address Table Size | 8K entries |
| Routing Protocol | Static routing |
| Management | Web-based management |
| Features | VLAN support, Quality of Service (QoS), IGMP snooping, port mirroring, flow control |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Jumbo Frame Support | 9KB |
| Operating Temperature | 50 °C |
| Humidity | 10% to 90% (non-condensing) |
| Input Voltage | AC 100-240 V |
| Storage Temperature | -40 to 70 °C |
Instructions for installing the switch on a desktop, shelf, or in a rack.
Configure, monitor, and display switch statistics using a web browser.
Use the Smart Wizard for quick initial configuration of the switch.
Configure IP address, subnet mask, gateway, system name, and timeouts.
Set up 802.1Q VLANs and asymmetric VLANs for network segmentation.
Configure 802.1X, Trusted Host, Safeguard Engine, and Broadcast Storm Control.
Test copper cables to identify errors and determine cable length.
To Next Page