5 Configuration D-Link Web Smart Switch User Manual
21
System Settings
By selecting Static and clicking Apply you can manually change the system IP Address, Subnet Mask, and
Gateway address. You can further configure and read more about the above settings in the “Setup Menu >
System > System Settings”. The default setting of System IP address is DHCP.
Figure 31 – Configure System IP address in Smart Wizard
NOTE: Changing the system IP address will
disconnect you from your internet connection,
please enter the correct IP address in the Web
browser and make sure your PC is in the same
subnet with the switch. See Login Web-based
Management Utility for detail description.
If you want to change the IP settings, click YES and start a new web browser.
Figure 32 – Confirm the changes of IP address in Smart Wizard
To Next Page
Loading...
Need help?
General