28D-Link DIR-615 User Manual
Section 3 - Configuration
This will allow you to open a single port or a range of ports.
Port Forwarding
Enter a name for the rule or select an application
from the drop-down menu. Select an application and
click << to populate the fields.
Enter the IP address of the computer on your local
network that you want to allow the incoming service
to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer
will be listed in the “Computer Name” drop-down
menu. Select your computer and click <<.
Enter the port or ports that you want to open. You
can enter a single port or a range of ports. Seperate
ports with a common.
Example: 24,1009,3000-4000
Select the type of protocol you would like to assign to the rule.
The schedule of time when the Virtual Server Rule will be enabled. The schedule may be set to Always, which will allow the
particular service to always be enabled. You can create your own times in the Tools > Schedules section.
Name:
IP Address:
Start Port/End
Port:
Traffic Type:
Schedule:
To Next Page
Loading...
Need help?
General
