Ad>INTERCONNECTION ADDRESS
, refers to the name
given to each of the ACTIVE DRIVER units when they are connected in a multiple pump
system. A cable connection needs to be made in order to achieve this condition. (Not
applicable to the AD M/M 1.1)
To access this setting, press [mode], [set] and [-] simultaneously for five seconds,
press [mode] until the display indicates
Ad
, and then flashes to
_._
which is the
default setting and is used when the unit is operating as a
STAND ALONE system. This condition can be changed by altering this parameter to
0.1
for Pump 1,
0.2
for Pump 2 etc.
Once the setting has been made, pressing the [mode] key will move the display to the
next settable parameter, pressing [set] will return the indication to the operating mode
of the system (Go or Sb)
Eb>ENABLING THE BOOSTER
, turn the alternating function
on in a multiple pumps system. (Not applicable to the AD M/M 1.1)
To access this setting, press [mode], [set] and [-] simultaneously for five seconds,
press [mode] until the display indicates
Eb
, and then flashes to
02
which is the
default setting. This condition can be changed by altering this parameter to
03
. This
will identify the order in which the pumps will start.
Once the setting has been made, pressing the [mode] key will move the display to the
next settable parameter, pressing [set] will return the indication to the operating mode
of the system (Go or Sb)
These are the main parameters that need to be set by the installer.
The system is now ready for operation. Ensure there is not an open flow condition
present, as this will make the AD device ineffectual.
Programming > Resetting Error Conditions
For some malfunctions and shutdowns the AD makes a certain number of attempts to
automatically reset the system.
To Next Page
Loading...
Need help?
General
