DIGITAL INDICATOR
DN500N
18
SET AUTO-ZERO RANGE
F05
20
00
∫
99
It returns the displayed value to “0” when the weight is less than
setting value and steady.
※ With this mode, you can automatically set “Zero” without pressing “Zero” Key before you do measuring again.
(When the remaining value is less than the setting value).
※ EX) In case of a scale with Max display weight is 120.00Kg and the value of one division is 0.02Kg, F05 is set
as 30: when the remaining weight is +
(0.02∼0.30Kg) and steady lamp is ON, it automatically sets “Zero” and the
display will be returned to “0.00KG”.
DIGITAL FILTER RANGE
F06
9
1
∫
9
Weak
↕
Strong
Weak Vibration
↑
Strong Vibration
More Sensitive
Less Sensitive
※ This mode should be used after compensating the setting value according to the surrounding
condition (surrounding vibration).
※ To make the speed of display reply faster, please set the setting value small.
ZERO. TARE KEY OPERATION
● 0 “ZERO” Key is operated only when weight is steady.
F07
1 “ZERO” Key is operated even there is change in weight.
SET ZERO KEY RANGE
0 Within 2% of Maximum Capacity
1 Within 5% of Maximum Capacity
2 Within 10% of Maximum Capacity
● 3 Within 20% of Maximum Capacity
F08
4 Within 100% of Maximum Capacity
SET TARE KEY OPERATION RANGE
0 Within 10% of Maximum Capacity
1 Within 20% of Maximum Capacity
2 Within 50% of Maximum Capacity
F09
● 3 Within 100% of Maximum Capacity
SET HOLD FUNCTION
● 0 Held when maximum weight is detected: Peak-Hold
1
Display is held when Hold key is pressed or external input is made: Sample Hold
F10
2
Held for 8 sec averaging weight if Hold Key is pressed or external input is
made : Average Hold
To Next Page
Loading...
