DIGITAL INDICATOR
DN500N
2
1. INTRODUCTION
1-1 INTRODUCTION
Thank you very much for purchasing our industrial indicator.
This product has various functions as well as the functions of external interface.
It is designed to satisfy different kinds of requirement in the various industrial sites.
Its external design is also solid and elegant.
It is programmed in user’s friendly way for easy in use and the message display function
is built-in to help user’s easy understanding.
Please ready this instruction manual carefully before you use this product so that you can
use this product properly and apply all the functions of this indicator enough.
1-2 ATTENTION
· Do not drop or impact upon this indicator.
· Do not install this item in the place with a direct ray of light or strong vibration.
· Do not install this item in the place with high voltage or electric noise.
· Turn off the power switch before you connect this item to the external peripheral device.
· Do not sprinkle water on this item and always avoid it being exposed to rain.
1-3 SPECIAL FEATURES
· Self- diagnosis and self- error solution feature (Watch-dog) are built-in.
· The external input terminal is built-in. (4 terminals: Function Set-up by external input
set-up mode)
· Shielded counter plan against external Noise.(Photo-Coupler)
· Data Memory feature in case of power failure. (Back-up)
· Lexan Film is used on the display front so that it is safe from dust and moisture.
· RS-232C and Current Loop is installed as standard.
· Various Options.
① Analog Out-put (V-out) : 0∼10V, 0∼5V(advance order)
② Analog Out-put (I-out) : 4∼20mA
③ Serial I / F : RS-422, RS-485
④ BCD In-put : Part Number input
1-4 ACCESSORIES
· Power Code : 1 pcs
· FUSE : 2 pcs (Cylindrical,250V 10A small-sized)
· Load-cell Connector : 1 pcs(N16-05)
· Instruction Manual : 1
· Relative connector in case of installation of Option
To Next Page
Loading...
