AUTOMATIC ICEMAKER
After the refrigerator has been connected to the water supply,
move the wire lever arm on the icemaker into the down (ON)
position to start its operation The icemaker will fill with water when
the freezer reaches the proper temperature It may be 8 to 12
hours before the icemaker furnishes any usable ice cubes
Discard all the cubes from the first two or three batches made
These initial ice cubes may be irregularly shaped, discolored, or
contain impurities from the new water supply piping
When the ice cubes are ejected it is normal for several cubes to
be joined together at the ends They can easily be broken apart
The icemaker will continue to make ice until the supply of ice
cubes raises the wire lever arm, shutting the icemaker off
To manually stop the operation of the icemaker, move the wire
lever arm into the up (OFF) position
Certain sounds may accompany the various cycles of the
icemaker
• buzzing of the water valve
• running of the water as the tray fills
• rattling of the ice cubes falling into an
empty ice bin
If the ice is not used frequently, the ice
cubes will become cloudy, shnnk, stick
together and taste stale Empty the ice
storage bin periodically and wash it in
lukewarm water Rinse and dry thoroughly
ICE STORAGE BIN (DISPENSERMODELS)
I
iz
!
To avoud personal unjuryor property damage, observe the
follownng:
• Do not place fingers or hands on the automatic ice making
mechanism while the refrugerator usplugged in This wnll
help protect you from possible unjury It wnll also prevent
interference wnth mowng parts of the ejector mechanusm and
the heating element that releases the cubes
• Under certain rare circumstances, ice cubes may be
discolored, usually appearung wuth a green-bluish hue The
cause of thus unusual dnscoloratuon can be a combmatnon
of factors such as certain characteristics of local waters,
household plumbing and the accumulation of copper salts
in an mactwe water supply line which feeds the ice maker
Contunued consumptuon of such discolored ncecubes may be
unjurnousto health If such discoloration usobserved, discard
the ice cubes and contact your dealer to purchase and nnstall
a water line filter
• Water damage due to improper water connection may cause
mold/mildew growth
• Clean up water and ice spills to avoid personal unjury and to
prevent mold/mildew growth
To check the ice level or gain access to the ice storage bm, hft the
door on the bin
To Remove the Bin:
• Turn off the icemaker by mowng the
icemaker wire lever arm up to the
(OFF) position
• While holding the top edge of the ice
storage bin, grasp the lower edge of
the ice storage bin and pull down to
release the latch, then pull ice storage
bin out
To Replace:
• Reverse procedure to replace the ice
storage bin
• Turn the icemaker (ON) by Iowenng
the wire lever arm
Note: Beverages and foods should NOT be placed in the ice
storage bin for quick chllhng These items can block the wire lever
arm, causing the icemaker to malfunction
To Next Page
Loading...
Need help?
General
