AUTOMATIC ICE AND WATER D
(SELECT MODELS)
DISPENSING WATER AND ICE SPILL TRAY
ISPENSER
Notes:
• When using the ice dispenser for the first time, discard the first
two or three dozen cubes.
• When using the water dispenser for the first time, press the
actuator pad for ten minutes to bleed the air from the water line.
Discard the first five to six glasses of water dispensed. This will
ensure pure and fresh water for drinking.
DO NOT pour water into the Spill Tray grille at the bottom of the
dispenser area. This is a spill area, NOT a drain. Normal,
small spills wilt evaporate. Larger spills should be wiped up with a
soft cloth or sponge.The grille slides out for clean up.
It is recommended to clean the spill area occasionally to prevent
mineral deposits.
To dispense ice or water, position a glass against the top portion
of the actuator pad and press. Hold the glass up to the ice
opening to avoid spills.
To stop dispensing, release the pressure on the actuator pad and
hold the container in position momentarily to catch the last pieces
of ice or the last drops of water. The ice delivery door wilt remain
open for a short time.When it closes, a closing sound can be
heard.
CRUSH_ CUBE_ WATER PADS
,0,. i II -t;
The control pads are located on the dispenser control panel.To
select the desired function, touch the appropriate pad. When ice
cubes, crushed ice or water pads are touched the selection is
illuminated.
DISPENSER LIGHT
When the actuator pad is touched, the dispenser light
automatically illuminates. To manually turn the light on, touch the
"_'- pad.
To turn the light off, touch the pad again.
DISPENSER LOCK
To interrupt power to the water and ice dispenser so it cannot be
used, touch the _ pad 3 times within 10 seconds.
The lock pad is illuminated when the dispenser is locked. Touch
the pad 3 times within 10 seconds again to unlock the ice and
water service.
ICE AND WATER DISPENSING TIPS
• Some crushed ice may be dispensed even though cubed ice
was selected. This happens occasionally when a few cubes are
accidentally channeled into the crusher.
• Likewise, when changing from crushed ice to cubes, some
crushed ice may be dispensed. This may also happen if
irregular-sized cubes or ice chips are in the storage bin.
• If the "crushed" option is used frequently or exclusively, select
the "cube" option occasionally to clear any crushed ice that may
have built up in the chute.
• A slight pause may be noticed when dispensing crushed ice.
This is normal because the ice is being channeled to the
crusher. Crushed ice pieces will vary in size and shape.
• If the ice dispenser is not used frequently, ice cubes may clump
together and may need to be broken apart or discarded.
• Do not add ice to the ice storage bin which was not produced
by the icemaker. It may not crush and/or dispense properly.
• Avoid operating the ice dispenser continuously for more than
five minutes. Remove large quantities from the bin by hand.
• Water from the dispenser is not as cold as ice water.The first
glass or two of water dispensed each time may be warmer than
subsequent glasses.
• To avoid splashing, fill the glass with ice before adding water.
10
To Next Page
Loading...
Need help?
General
