MAINTENANCE
CONDENSER
Cleaning of the condenser is recommended every 3-6
months.
TO CLEAN:
• Raise Machine Compartment cover. Install hinge stop. (For
overlay models only.)
• Turn the power to the unit OFF (O)
using the Main Power switch.
• Use the soft brush vacuum
attachment to loosen dust and lint
on the condenser fins. Vacuum to remove the soil.
• After cleaning, turn the Main Power switch back ON.
• Remove hinge stop. (For overlay models only)Lower the
machine compartment cover.
LIGHT BULB RELPACEMENT
UPPER FRESH FOOD AND FREEZER COMPARTMENTS
There are light bulbs at the top of each compartment.
To Replace the Bulb Behind the Upper FoodSaver TM
Drawer:
• Turn the power OFF (O) to the refrigerator at the Main Power
switch in the upper machine compartment.
• Unload and remove the upper FoodSaver TM drawer.
• Remove the FoodSaver TM Air Diverter located at the rear of the
fresh food compartment.
• Lift up and remove the glass shelf.
Air Diverter
Strip
Shelf
To Access the Upper Lightbulb Area in Either
Compartment:
• Push in on the fingertabs located behind the electronic
control panel at the top of the
compartment.
• Lower the light shield.
• Replace the burned out bulb(s)
with standard A15-40 watt
appliance bulb(s), available from your dealer.
• After replacing the bulb(s), push the liaht shield UD into its
original position.
LOWER FRESH FOOD
COMPARTMENT
There is a T8-40 watt bulb located behind each FoodSaver TM
drawer. Replacement bulbs are available from your dealer.
Important: To avoid damage to the FoodSaver TM drawers,
power must be turned OFF (O) at the Main Power switch before
changing the bulb.
• After the shelf is removed, 2 mounting screws are visible behind
the drawer. Using a 114" hex head screw driver,
remove these screws.
• Slide the compartment assembly forward.
• Unscrew the bulb and replace with a new T8-40
watt bulb.
Slide the assembly back into its original position. Align the
screw holes, making sure air ducts are in alignment. Replace
the two screws. Replace the shelf and the air diverter strip.
Reinsert the drawer into the compartment.
• Turn the power to the refrigerator back (ON).
IMPORTANT: Do not remove the foam piece between the
FoodSaver TM drawers.
16
To Next Page
Loading...
Need help?
General
