BEFOREYOU CALL FOR SERVICE
FRESH FOOD OR FREEZER DOOR DIFFICULT TO OPEN.
• Due to air flow between the compartments, it may be difficult to
open the doors for several seconds after one of them is closed.
DISPENSER WILL NOT DISPENSE WATER OR ICE (SELECT
MODELS).
• A water filter, or the filter bypass plug must be in place.
• Door is open.
• Water supply turned off.
• Water pressure too low.
• Lock switch on.
• Ice jam in the dispenser.
• Icemaker not operating.
WILL NOT RUN.
• Power cord not plugged in.
• No power at the electrical outlet.
• Circuit breaker tripped or house fuse blown.
• Main power turned OFF (O).
• Touch the ON/OFF pad.
• Check Sabbath mode setting.
FOODSAVER TM TEMPERATURE READOUT IS NOT WITHIN
TARGET RANGE.
• For best results, refrigerator and freezer controls should be left
at the factory settings.
• After drawer openings, the addition of a new toad or changing
settings, the readout may vary.The temperature will recover in a
short period of time.
REFRIGERATOR COMPARTMENT TOO COLD.
• Refrigerator temperature set too cold.
REFRIGERATOR OR FREEZER COMPARTMENT TOO WARM.
• Refrigerator or freezer temperature set too warm.
• Prolonged door openings.
FREEZER NOT FREEZING PROPERLY.
• Products with high sugar content may not harden completely
when frozen (ice cream, concentrated juice, etc.) Do not store
in door.
• Adjust freezer temperature to a colder setting.
RUNS TOO LONG/TOO FREQUENTLY.
• Today's energy efficient refrigerators are larger and require
more running time to maintain stable temperatures.
• Prolonged door openings.
• Too many door openings.
• Condenser needs cleaning.
• The door not sealing (due to a package or a container holding
door open).
• Warm room temperature.
NOISY OPERATION.
• Cabinet not level.
• Weak floor.
• See Normal Operating Sounds
ICE CUBES EVAPORATE.
• Cold air moving over the ice cubes causes shrinkage, especially
with limited usage. This is normal.
AUTOMATIC ICE MAKER NOT OPERATING.
• Wire lever arm in up (OFF) position.
• Water supply turned off.
• Water pressure too low.
• Freezer too warm.
• Install filter or filter bypass.
FRONT CABINET SURFACE WARM TO THE TOUCH.
• Special design to limit condensation during periods of high
humidity.
ODOR IN CABINET.
• Odor producing foods should be covered or wrapped.
• Interior needs cleaning.
WARM AIR FROM MACHINE COMPARTMENT.
• Normal air flow for condenser circulation.
CABINET VIBRATES.
• Cabinet not level.
• Weak floor.
• Improper installation.
MOISTURE ON INSIDE CABINET WALLS.
• Can occur during hot, humid weather with frequent or prolonged
door openings.
• Door not closed properly.
EXCESSIVE MOISTURE IN OR AROUND FOODSAVER TM
DRAWERS.
• Food not wrapped properly.
• Hot, humid weather.
NO TEMPERATURE READOUT IN THE FOODSAVER TM
DRAWER DISPLAY.
• The Normal Cold setting has been chosen.
21
To Next Page
Loading...
Need help?
General
