ELECTRONIC CONTROL CENTER
TEMPERATURE ADJUSTMENTS
• Allow the temperature to stabilize for 24 hours after loading the
refrigerator before making any temperature adjustments.
• The first touch of the up or down arrow shows the current
temperature set point.
• Subsequent touches of the :_pad raise the temperature set
point or the"Y:_pad lowers the temperature set point.
POWER INTERRUPT
When enabled, Power Interrupt wilt record
and display the highest temperature reached
in the fresh food and freezer compartments
during a power outage. If an outage has
occurred, the display wilt alternately show the
current compartment temperatures and the
POWER
iNTERRUPT
highest compartment temperatures reached when the power was
out.
• The display will show the new set point for approximately three
seconds, then return to the actual temperature currently within
that compartment.
• Limit temperature changes to one degree at a time. Allow the
new temperatures to stabilize for 24 hours before making a new
temperature adjustment.
DOOR ALARM
The Door Alarm wilt alert you when one of the
doors has been left open for 10 continuous
minutes. When this happens, the compartment
light will go out and a chime will sound every
few seconds until the door is closed or the
DOOR
ALARM
Door Alarm pad is pressed to deactivate the function.
• Press the Door Alarm pad to activate. A chime will sound and
ON will illuminate.
• Press the Door Alarm pad again to deactivate.
• When the alarm has sounded, close door to reset.
OR
reactivate, if desired.
WATER FILTER
GOOD is illuminated when a water filter
has been installed. It wilt not illuminate
when the filter bypass is in place (see
page 11 for information on installation of
the water filter or bypass),
Press the Door Alarm pad to deactivate.Press again to
WATER FILTER
• Touch the RESET pad to enable this feature.The RESET pad
will illuminate.
• After a power outage or interruption, touch the RESET
pad once to resume displaying the current compartment
temperature.
• The RESET pad will continue to be illuminated and enabled.
• Touching the RESET pad a second time will turn off this
function and the pad will not be illuminated.
Note: Frozen foods which have thawed completely should not
be refrozen. Discard these items. Fresh, perishable items stored
above 40° for two hours or longer should also be discarded.
FAHRENHEIT/CELSIUS DISPLAY
The control can be changed to display temperatures in either
degrees Fahrenheit or degrees Celsius.
• Open the machine compartment at the top of the refrigerator.
• Set the switch to the desired mode - °C or °F.
All temperature displays wilt change to the selected mode,
including the FoodSaver TM drawer displays.
_:REEZ_8 RIEF_!G_ATOR
• ALERT wilt illuminate when 90 percent of the volume of water
for which the filter is rated has passed through the filter.
OR
Eleven months have elapsed since the filter has been installed.
CHANGE illuminates when the rated volume of water has
passed through the filter or 12 months have elapsed since the
filter was installed. A new filter should be installed immediately
when CHANGE is illuminated.
When the new filter is installed, the GOOD light will reilluminate.
Note: Power to the refrigerator must be ON when the filter is
changed for the water filter monitoring system to reset
and change back to the "GOOD" indicator.
To Next Page
Loading...
Need help?
General
