Reinstalling the Oven Door(s)
WARNING
Failure to fully rotate the hinge catches wil! result in
safety hazard and may cause personal inju[y due tO
the door falling off its hinges Also damage t0the OVen
and/or improper door alignment may occur.
, On double ovens, install the upper door first to avoid
damage.
1. Grasp the oven door on opposite sides and lift it until
the door hinges are aligned with the openings in the
oven frame.
,
,
Holding the door at about a 30 ° angle from the horizon-
tal, slide the hinges into the openings until the bottom
hinge arms drop fully into the hinge receptacles.
Lower the door to the fully opened position. Rotate both
hinge catches toward the oven. Open and close the
door slowly and completely to ensure that it is properly
installed.
Insert door at
30 ° angle
Verifying Proper Operation
1. Peel off the protective layer of plastic that covers the
stainless steel surfaces.
,
3.
,
Remove any packaging from inside the oven.
Slide the oven racks onto the supports inside the oven
chamber according to the use and care manual.
Turn on power to the oven at the circuit breaker or fuse
box.
,
6.
,
Set the clock according to the use and care manual.
Press the BAKE key on the control panel (on double
ovens press the BAKE key for the upper oven). The
default bake temperature should appear on the display.
Press START. After approximately 3 minutes, the oven
should begin to heat.
8. Press CANCEL/SECURE.
,
If the oven does not operate properly, follow these trou-
bleshooting steps:
¢ Verify that power is being supplied to the oven.
¢ If power is being properly supplied, turn off power at
the circuit breaker or fuse box and check the electri-
cal connections.
¢ Turn on power and repeat the above heating test.
If the appliance still does not work, contact Dacor
Distinctive Service at (877) 337-3226. Do not
attempt to repair the appliance yourself. If you need
service, be sure to have the model and serial num-
bers available when you call. See inside cover for
location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.
Catch
10 c_acar