17
Installing the Burner Components
Installation Instructions
Stack Burner Installation
Burner Head
Crown Burner
Stack Burner
Spill Tray
Burner Ring
Ridge on bottom
of burner cap
STEP 1: Put burner ring
on top of the head.
STEP 2: Turn ring until
it drops into place. Twist
back and forth to assure
proper seating.
STEP 3: Install burner
caps. Ridge on cap must
surround top of ring.
Burner Head
Crown Burner Installation
Burner Base
Burner Ring
Ridge on bottom
of burner cap
STEP 1: Install
burner head. Put
locating tab in
keyed hole.
STEP 2: Install
burner ring. Line up
ring tabs with head
slots. Twist back
and forth to assure
proper seating.
STEP 3: Install burner
cap. Ridge on cap must
surround top of ring.
Keyed Hole
WARNING
Never attempt to operate the cooktop section of the range with
any of the burner rings, burner caps or grates removed.
Remove the burner rings, burner caps and grates from their
shipping packages.
Install the burners as shown. The location, type and size of
the burners varies with the range model number.
Gently set the grates on top of the spill tray. Put the legs
of each grate inside the corresponding dimples. On model
ER36D, the largest grate goes in the center.
•
•
•
To Next Page
Loading...
Need help?
General