Be sure to turn the ignition switch OFF
when replacing the bulb.
Do not use bulbs other than that
specified.
After installing a new bulb, check that
the light operates properly.
[HEADLIGHT BULB]
① Put your hand under the front under
cover and stretch it to the back of the
headlight bulb.
② Remove the rubber cover.
③ Turn the socket clockwise, and remove
it.
④ Slightly press down on the bulb and
turn it counterclockwise.
⑤ Install a new bulb in the reverse order
of removal.
HEADLIGHT BULB : 12V 35W/35W
[TAIL/STOPLIGHT BULB]
① Loosen the 2 tapping screws and
remove the tail light lens.
② Install a new bulb in the reverse order
of removal.
TAIL/STOP LIGHT BULB : 12V 5W/21W
43
BULB
SCREWS
BULB
SOCKET
TAIL & STOP LENS
RUBBER COVER
BULB REPLACEMENT
CAUTION
●The light bulb becomes very hot
while the light is ON, and remain
hot for a while after it is turned
OFF. Be sure to let it cool down
before servicing.
●Do not put finger prints on the
headlight bulb, as they may create
hot spots on the bulb and cause it to
break. Wear clean gloves while
replacing the bulb.
If you touch the bulb with your
bare hands, clean it with a cloth
moistened with alcohol to prevent
its early failure.
●When replacing the head light
lamp, stop lamp and winker lamp,
use only specified lamps. Do not
use the lamp exceeded its capacity.
the battery can be overcharged and
fire can be occurred due to the
burned wire.
**E-5 OWNERS(1~47) 02.11.5 4:3 PM 페이지43
To Next Page
Loading...
Need help?
General
