No Problem Cause Solution
1 No electric power
Power connection
alarm
Check that the plug is correctly inserted into
the power outlet
Rated power
Check if your power supply is in the range of
AC100-240V, 50/60Hz
FUSE shortcut
Check if FUSE is in the state of shortcut.
(FUSE is located inside AC INLET.)
2
Power on but not
operating
Power supply alarm Turn power to the controller off and on
3
Noisy during
operating
Setting condition
Check that the device is installed horizontally
or fixed the screw hard-locking.
Check that there is nothing laying on top of
the device or underneath.
4 No air in the hose
Hose connection
alarm
Check that the hose is inserted correctly into
the device.
Bent hose Check that the hose is not bent.
No Problem Cause Solution
1 Weak air injection
Air hose damage
Contact the seller if there is a defect in the
inner hose or cuff connection.
Air hose socket
damage
Defect of Inner parts
of cuff
2
Power on but not
operating
Defect of Inner parts
Check that the plug is correctly inserted into
the outlet.
6-2. General Troubleshooting
6-3. Troubleshooting
32
UserManual_DTS-3000_170223_인증용.indd 32 2017-02-23 오후 2:06:08
To Next Page
Loading...
