5.
DIRECTIONS FOR INSTALLATION AND USE
HOW TO INSTALL THE WASHING MACHINE
THE SELECTION OF THE INSTALLING PLACE
I
nstall the washer on a horizontal solid floor.
I
f the washer is installed
on an unsuitable floor, it
could make considerable
noise and vibration.
I
NSTALLATION OF THE UNDER BASE COVER
HOW TO INSTALL ON AN INCLINED PLACE
1
6
Never install in these places
• The place where it would be exposed to
direct sunlight.
• The place nearby a heater or heat
appliance.
• The place where it would be supposed
to be frozen in winter.
• The kitchen with coal gas and a damp
place like a bathroom.
• The proper installation of the washing machir
can increase the wash effectiveness and the
l i
fe of it.
After installing the washing machine, close the
under-base cover.
O
Push the under-base cover into the end,
which decreases the noise made by this
washer.
----------------
•, .
„•
I
f the washer is installed on an unsuitable floor, it could make
considerable noise and vibration, and could cause a malfunctic
Use the height adjust rubber to adjust the washing machine s(
that it sits properly.
NOTES:
The openings must not be
obstructed by carpeting
when the washing machine
i
s installed on a carpeted
floor.
1O
Height Setting
0
Check the Horizontal
Status
•
After controlling the height
•
Check the position of tub
by turning the adjustable
above the center of the
l
egs, let the washer put
washer.
down to the ground.
To Next Page
Loading...
