Fan Speed
Press the Speed Button (13) to select the airflow speed:
• Low Fan Speed – the Low Fan Speed Indicator (21) will illuminate.
• High Fan Speed – the High Fan Speed Indicator (20) will illuminate.
In Continuous drying mode and Sleep mode the airflow speed cannot be adjusted.
Child lock
Hold the Child Lock Button (12) for 3 seconds to turn the child lock function on
and off.
The Child Lock Indicator (19) will illuminate when the lock
Water Tank Full Alarm
When the Water Tank (8) is full, the Tank Full Indicator (26) will illuminate and the
unit will “buzz” 5 times.
To clear the alarm:
• When the “buzz” sounds, press any button to stop the alarm. The compressor
and fan will shut down and all functions will pause until the Water Tank (8) has
been emptied and replaced.
To empty the tank:
• Grasp the indents at either side of the Water Tank (8)
and pull the tank free from the Main Body (4) with
both hands.
• Remove the lid from the Water Tank (8) and empty.
• Place the lid back on the Water Tank (8) and replace.
Continuous drainage
If preferred, continuous drainage can be used with the appliance rather than
emptying the Water Tank (8).
For this option:
• Remove the Water Tank (8) as described above.
• Fit the Drain Hose (18) to the hose point on the
rear of the Main Body (4), arrowed right.
• Replace the Water Tank (8) ensuring that the
hose fits through the groove in the tank body.
• Run the hose into a suitable drainage point.
To Next Page
Loading...
