- 21 -
6) Position fuel control lever at the wholly opened
position.
7) Continuely feed fuel with pumping priming pump as
slowly turning crankshaft clockwise.
Immediately stop turning the crankshaft when fuel
stop from #1 devilvery valve holder.
This crankangle position is the injection starting of
the engine.
8) Make sure that crankshaft pulley and point is
specifically on injection starting angle line.
Blow out remained fuel from delivery valve holder.
EJM1042S
EJM1054I
EJM1044I
4) Remove the delivery valve holder (1), the valve
seat (2), valve spring (3), the delivery valve (4)
from the #1 plunger.
5) Assemble the delivery holder (1) and tighten
specified torque.
Do not assemble valve spring, valve seat and
delivery valve.
These parts will be reassembled later.
EJM1041S
aû
To Next Page
Loading...
