- 86 -
Inspection and Repair
Correct and replace it if there are worn or defect parts.
¥
Push Rod Spring
Check wear, damage and corrosion, etc.
¥
Nozzle Holder Push Rod
1. Check the nozzle holder push rod curvature.
2. Check whether connected surface with needle
valve is damaged or not.
¥
Injection Nozzle
Check the needle valve, valve seat, nozzle hole
whethere it is contaminated with the carbon or not, if
so, replace the nozzle and needle valve.
EJM5005S
EJM5006S
EJM5007S
To Next Page
Loading...
