15
1.Press the ON/OFF button on the remote control to
turn the unit on; the On LED will light on the indoor
unit and “ON” will light in the remote display.
2.Press the MODE button to select the desired mode.
Then, set the desired temperature using the TEMP.
▲ or ▼ buttons.
3.
Press the SLEEP button on the remote controller. The
unit will then be in the sleep mode and will cool the
room to the desired temperature. After a while the unit
will increase the temperature again.
This process will then repeat.
TO SET SLEEP MODE
When you are going to sleep, select this feature and the unit will cool off the room to the desired temperature and then
increase that temperature throughout the night.
1.Open the indoor unit’s cover and make sure the
EMERGENCY/REMOTE switch is set to the EMER-
GENCY position.
TEST/EMERGENCY/REMOTE Switch
3.
To turn the unit off, slide the
EMERGENCY/ REMOTE
switch to the REMOTE position.
2.The unit will then turn on and depending on the room
temperature, it will select the cool or dehumidifier
mode, fan speed and fan direction automatically.
EMERGENCY OPERATION
If the remote control is lost, broken or has no batteries, follow the procedures below:
EMERGENCY/REMOTE Switch
TEST/EMERGENCY/REMOTE Switch
EMERGENCY/REMOTE Switch
TO CANCEL SLEEP MODE:
To cancel sleep mode,
press the SLEEP button
again; the SLEEP indicator
will disappear in the dis-
play.
1. The unit is tixed “MILD” mode on production.
2. Press the “TURBO/MILD” button for powerful cooling.
3. When press the “TURBO/MILD” button one more time, it will be back to “MILD” mode.
TO SET TURBO/MILD MODE
To Next Page
Loading...
Need help?
General
