10
EN
water.
5.Press the brush plate motor switch , and then press the suction
motor switch.
Note: It is recommended to use a cleaning speed of 45-60 meters
per minute.
During machine operation
WARNING: Fire or explosion hazard, do not pick up
ammable materials or reactive metals.
1.Each cleaning path overlaps by 5 cm.
2.Keep the machine moving to avoid damaging the ground.
3.If there are drag marks on the oor after the squeegee absorbs
water, use a rag to wipe the adhesive strip to remove the garbage
and clean it in advance to prevent drag marks.
4. Do not operate the machine on slopes with a slope exceeding
5% (3°).
For safety : When using the machine, move slowly on
slopes and slippery surfaces.
5.If there is too much foam, defoamer must be used and the
original solution of defoamer must be poured into the sewage
tank.
Note: Do not let foam enter the lter to avoid damaging the
vacuum suction motor. The foam will cause the lter switch to fail.
6.Use the double wash method to clean extremely soiled areas.
7.First raise the squeegee to clean, let the solution soak the oor
for 3-5 minutes, lower the squeegee and clean again.
8.Replace brushes or scouring pads as necessary (bristle shorter
To Next Page