11
than 2cm must be replaced).
9.Observe the power consumption on the battery power meter
(refer to “Battery Power Meter”).
10.Check the remaining liquid volume through the clean water
tank level gauge. The traditional oor scrubbing method uses
about 10 liters every 10 minutes.
11.When the solution in the clean water tank is used up, rst
empty the sewage tank to discharge the sewage, and then rell
the clean water and detergent.
12.When workers leave the machine, park the machine on level
ground and remove the key.
13.After cleaning, perform daily maintenance procedures.
Battery power display
The display will show the battery level. When the battery is fully
charged, all indicators light up;As the power is consumed, the
indicator lights will turn off from right to left; if the battery power
falls below a certain level, an alarm will appear to prompt for
charging.
Water tank drainage
The sewage tank should be drained and cleaned after each use,
and the clean water tank should be cleaned regularly.Move the
machine to a drainage location and turn off the power key, follow
the drain instructions below to drain the water, and throw out the
waste from the solid-liquid separation basket.
Discharge sewage tank
1.Unscrew the sewage tank drain pipe cover in the
counterclockwise direction and remove it.
2.Open the recovery tank cover and ush the tank.
3.Remove and rinse the oating lter in the recovery tank.
4.Take out the solid-liquid separation basket, dump the garbage,
To Next Page