7
1. Park the machine on level ground and remove the key.
2. Lift the recovery tank to expose the accessible battery.
3. Carefully install the battery in the battery compartment and
connect the battery cables as
shown in the gure below.
4. Before connecting the battery, please make sure the electrodes
and terminals are clean,
and use electrode cleaning uid and wire brush if necessary.
5. Instructions: Apply a thin layer of metal-free lubricant or
protective spray to the
connected wiring to prevent battery corrosion.
6. After the battery is installed, please check the battery level on
the battery gauge and charge the battery if necessary.
3. MACHINE CLEANING METHOD
Cleaning method
Manually control the water valve to adjust the amount of water
from the clean water tank and detergent to the ground; the brush
uses a solution of detergent and water to clean the oor; while the
machine is moving forward, use a squeegee to suck the sewage
on the oor into the sewage tank.
Brushes and scouring pads
To ensure optimal performance, use the correct brush type for the
cleaning job.
Recommended brushes and scouring pads are as follows:
- Soft nylon brush: Recommended for cleaning coated oors
without damaging the oor, cleaning without leaving scratches.
- Polishing pad:For maintenance of highly glossy or polished
To Next Page