EasyManua.ls Logo

Daewoo DSD600 - Machine Maintenance

Daewoo DSD600
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
facilitate ventilation.
5.Plug the charger’s AC (alternating current) power cord into a
well-grounded electrical outlet.
6.Plug the charger’s DC (direct current) cord into the battery
charging socket behind the recovery tank.
7.The charger will automatically start charging and will
automatically turn off when fully charged.
8.The charging time must be guaranteed to be 12 hours. If the
device is not used for a long time, the battery must be charged in
time. Recharge every 20 days.
Illustrate: The machine will not operate when connected to the
charger.
Notice:While the charger is charging, do not unplug the charger’s
DC cord from the socket on the machine to avoid arc discharge.
If charging must be suspended during charging, please unplug
the AC power cord rst.
WARNING:Fire or explosion hazard. The battery releases
hydrogen gas. Please keep away from sparks or open re
sources. Keep the battery compartment open when charging.
9.After charging is completed, check the electrolyte level again.
7. MACHINE MAINTENANCE
As long as daily, weekly and monthly maintenance procedures
are followed, the machine can be kept in optimal working
condition.
WARNING:Risk of electric shock. Please disconnect the
battery wiring before maintaining the machine.