9
5.To remove the needle holder and brush, step on the brush head
lifting pedal to lift the brush head off the ground, and press the
brush plate motor switch.
6. MACHINE OPERATION
For safety: Do not operate the machine without reading and
understanding the operating manual.
WARNING:
1. Fire or explosion hazard. Never operate the machine near or in
the presence of ammable liquids, gases or combustible dusts.
2.When using equipment in low-temperature environments
(subzero), be careful to prevent freezing.
Check before operation
- Sweep the dust from the oor.
- Check the battery level on the battery gauge. (Refer to the
battery gauge)
- Check the pad/brush for wear.
- Check the wear of the squeegee rubber strip and adjust the
angle appropriately.
-Make sure the recovery tank is empty and has a clean oating
lter installed.
- Check the brush head’s water-retaining skirt for wear.
Operate machinery
1.Turn the main power key to the (I) position.
2.Pull down the squeegee lifting handle to lower the squeegee
assembly to the ground.
3.Press the brush lift pedal to lower the brush tray to the ground.
4.Use the water control button to adjust the appropriate amount of
To Next Page