12
Problem
Check Point
Cause Solution
Problem
Check Point
Cause
Solution
Pulsator rotate
only in one
direction.
There is excessive
noise during
washing.
The Spin Dryer
does not rotate.
Is the wiring of Condenser properly
connected?
Are there strange noise from Tub when
the Pulsator rotates?
Impurtities between
Pulsator and Tub.
Pulsator improperly
assembled.
The contact of Door
Switch is open.
Motor does not start due
to opening the Condenser
circuit.
Tighten the Pulsator fixing
screw.
Keep the Door Spin *O
closed during spin.
Reconnect.
Is the wiring of wash timer properly
connected?
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
Is the Door Spin *O open?
Is there a whirring sound form the
Spin Motor when turned ON?
Is the Condenser properly connected?
Improper wiring.
Improper wiring.
Reconnect.
Defective Wash timer.
Reconnect the Wash
Timer
Replace Wash Timer.
Remove impurities after
disassembling Pulsator.
Something is in contact
with the Pulsator Pulley or
Motor Pulley or other
rotationg parts.
Adjust the parts so that
there are no impurities in
contact with rotating parts.
NO
NO
YES
Concerning Spin
To Next Page
Loading...
